1977-1982 Corvette Sunvisor Installation

Nothing is as annoying as driving your Corvette down the road and having the sunvisor flop down in front of you. You push it back up and it falls down again. After years of use, the sunvisors’ hinges lose their tension and will not stay in place. The sunvisors themselves also deteriorate and start to separate inside which adds to your Corvette interior problem. The total cure is a simple call to Zip Corvette Parts, 8067 Fast Lane, Mechanicsville, VA 23111, (800) 962-9632. They can supply new Corvette sunvisors, arms and mounting hardware. Our Project 77’s sunvisors were doing the dreaded sunvisor flop so we decided to replace them. The entire job took less than one hour from start to finish. It is a quick and easy fix, so let’s get started. 1977-1982 Corvette Sunvisor Installation:

Step 1

01: Is this the only way you can keep your sunvisor in place?

Step 2

02: Here are the new sunvisors, arms and mounting hardware supplied by Zip Corvette Parts. The only other things you will need are a few common hand tools and a little time.

Step 3

03: Use a small flat blade screwdriver to remove the sunvisor arm end cap. It will pry out easily.

Step 4

04: Remove the sunvisor arm retaining washer. This will have to be pried off. These cannot be re-used so you will need new ones.

Step 5

05: Pull the tension spring out with a pair of needlenose pliers.

Step 6

06: A flat punch and hammer can be used to tap the sunvisor arm out of the windshield mount.

Step 7

07: Install the new Corvette sunvisor arm into the sunvisor. Spread a small amount of white lithium grease on the elbow end. This will help lubricate the arm where its positioned in the windshield mount.

Step 8

08: With the sunvisor arm tapped into place in the windshield mount, slide the tension spring over the sunvisor elbow shaft. Now place the toothed retaining washer over the end of the shaft. Place a 1/4” drive 3/8” deep socket over the washer and use a hammer to tap it down onto the ridged portion of the sunvisor arm shaft. The washer will grip the ridges on the shaft while compressing the springs and put tension on the sunvisor arm.

Step 9

09: Snap the end cap back into place.

Step 10

10: There you have it! New sunvisors installed that not only look good, but stay where you put them.

Stopping The Sunvisor Flop: Replacing Sunvisors and Arms for 1977 to 1979 Corvettes

Source: Zip Corvette Parts
8067 Fast Lane | Mechanicsville, VA 23111 | (800) 962-9632

Corvette Parts List Related to Article:

One Comment

  1. Jeffrey Allen Williams

    Thank you for the detail instructions and pictures. I appreciate you taking the time to make this instructional lesson. Worked perfect for me. Thanks again!

    Semper Fi ,

    Jeff Williams
    77 Corvette

Leave a Reply

Your email address will not be published. Required fields are marked *