Corvette 4-speed Shifter Rebuild

Is your shifter so loose that you sometimes have to hunt for each gear? Do you have to make a perfect shift pattern to get it into gear? Does the shift handle move around so much that you feel like you are stirring a mystery brew with a spoon? These symptoms all point to a worn shift mechanism. Through use the levers and pins all wear causing hard or sloppy shifting. The only thing you use to be able to do was buy a new shifter and mechanism, but that has all changed. Zip Products, Inc., 8067 Fast Lane, Mechanicsville, VA 23111, 1-800-962-9632, has come up with the perfect solution, a 4-Speed Shifter Rebuild Kit. These Kits cover the years from 64 to 81 and eliminate the need to replace the shifter and mechanism. This is really a complete rebuild kit. It includes instructions, a new ball, reverse T-handle with rod, springs, shafts, pins and two different interlock levers to tighten up the mechanism. The best part about this Kit is that it is inexpensive and relatively easy to do. Our Project 77 had an extremely worn shifter in it so we ordered a new Rebuild Kit from Zip. The installation was easy, only took about 4 hours, and made our sloppy shifter into a real slick shifter. Now let’s get our hands dirty and rebuild that 4-speed shifter.

05: The shift handle can now be removed from the bracket. Remove the spring clip and slide the pin out of the handle and bracket. The shift handle can now be pulled out of the bracket from the bottom. We had to remove a nut and bolt on our shifter. It had been repaired with a 1/4” bolt and nut instead of the correct pin and spring clip.

06: The shift levers and interlock can be removed from the bracket. Again, make a diagram or mental note so that you remember how each lever is placed in the bracket. Here is our shifter and mechanism totally disassembled with all the pieces displayed.

07: Thoroughly clean all of the levers and brackets in a parts solvent (mineral spirits will work). The cleaner the better. Check all parts not supplied in the Kit for cracks, wear or damage. These parts are usually all reusable but if any are damaged, contact Zip for replacements.

08: We wanted everything to look new so we sprayed the levers, brackets and shift rods with Eastwood’s Spray gray.

12: Now you will slide the shift handle bracket into the shift lever bracket. Keep the shift lever falling to the left side of the interlock (when looking from the back of the shifter). When they are aligned, install the shaft and lock into place with the E clip. NOTE: This is the hardest part of the whole assembly. Patience is the Key. Take your time. Remember to lubricate all the areas where the two brackets meet and keep the slot in the shift levers lined up during re-assembly.

13: Install the shift rods with new spring clips. Do not use cotter keys. These spring clips do not come with the Shifter Rebuild Kit but are available from Zips separately. Also remember to lubricate all mounting points with white lithium grease.

14: Re-install the shifter mechanism into the car as per your shop manual. Now is the perfect time to replace those worn or split shift boots. Remember you can have both an upper and lower shift boot. Place the T-handle with lockout rod and spring into the shifter handle.

15: Install the new supplied shift ball to complete the assembly. Now take your Corvette out and see what a new shift mechanism feels like.