LEFT: Next, unscrew the end plug, using caution because they can be tight and you do not want to strip the slot. If you run into difficulty, you may need to apply some heat with a torch to get it to break free. If you do not have access to an torch, then you can pick up some MAPP gas at your local hardware store. Make sure you use MAPP gas though because propane will not get hot enough to make much difference.

BELOW LEFT: With the end plug off, remove the spring and ball stud from the end. You may need to use a flat-blade screw driver to pry them out.

BELOW RIGHT: Now you can remove the ball stud by sliding it towards the end of the relay rod, then pulling straight out. You will see the cut out in the relay rod for the ball to fit through.

<% Set Ad = Application("Ad") %> <% arrTags = Array("ad.size.promo", "ad.border.0", "site.corvettemagazine") %> <% = Ad.GetAd(Response, arrTags, Null ) %>