LEFT: This is the retaining pin, spring, and locking cap that hold the brake shoes to the backing plate.

BELOW LEFT: Insert the pin through the backing plate, then through the shoe. Once you have the pin through the shoe, install the spring and the cap. Rotate the cap a quarter turn to lock it into place.

RIGHT: This is what you should see after both shoes are installed. Note that you also have to insert the shoes into the ends of the brake cylinder.

BELOW RIGHT: With the shoes assembled, install the upper tension springs. These will not require a special tool, just a set of needle nose pliers and a flat-bladed screwdriver. And maybe a little extra patience too. Don’t forget to install the retaining plate before installing the springs. After both springs are on, apply a small amount of lithium grease where the springs ride on the pin.

<% Set Ad = Application("Ad") %> <% arrTags = Array("ad.size.promo", "ad.border.0", "site.corvettemagazine") %> <% = Ad.GetAd(Response, arrTags, Null ) %>