LEFT: If you look at the side of the headlight motor, you will notice a small bracket that bolts to the headlight frame and the hood hinge. Unbolt the 13mm carriage bolt between the bracket and the hood hinge, then remove all of the 10mm bolts that hold the headlight motor to the headlight frame. Then you can remove the motor.

BELOW LEFT: With the motor out, remove the wire clip from the locking knob. Just pull it out of the housing.

BELOW: Use a Phillips screwdriver to remove the screws that hold the housing together. Silicone sealer was used at the factory to keep water out, so you may need to use a small putty knife to separate the housing.

<% Set Ad = Application("Ad") %> <% arrTags = Array("ad.size.promo", "ad.border.0", "site.corvettemagazine") %> <% = Ad.GetAd(Response, arrTags, Null ) %>