LEFT: After unplugging the connector (with green, white, and gray wires) near the front side marker light, locate the gray knob at the bottom of the headlight motor. Remove the locking strap from the knob and turn the knob until the headlight is in a position to where you can remove the side screw from housing cover.

BELOW LEFT: This is the side screw we are going to remove. This is a special screw so make sure you do not misplace it.

BELOW RIGHT: With the side screws are out, remove the front Torx screws, then separate the headlight cover from the headlight housing. Remember to lay it on something soft because you do not want to scratch the paint.