LEFT: The lower radio mounting bracket can be removed from the radio using a 3/8-inch nut driver, then disconnect the radio antenna lead. At this point, the center gauge bezel can be removed. Pull it out gently from the top, then lift upwards to release the two lower mounting studs from the console.

BELOW LEFT: Unsnap the power harness from the radio at this time, followed by the speaker harness. Then the green and black speaker leads can be snipped with a wire cutter because they won't be reused.

we’re just touching on some of the highlights here. The whole job took about four hours and only simple tools were required.

<% Set Ad = Application("Ad") %> <% arrTags = Array("ad.size.promo", "ad.border.0", "site.corvettemagazine") %> <% = Ad.GetAd(Response, arrTags, Null ) %>